Technical Information
87
PW 6xx7
Parameter Setting options Notes
Rhythm User-defined On time (drum rotation) from 2 s to 99 s in 1-s
steps with sum of on time and pause always ≥
15 s
Off time (pause) from 2 s to 99 s in 1-s steps
with sum of on time and pause always ≥ 15 s
Speed Basic setting: Normal
No No rotation
Normal PW 6107: 44 rpm; PW 6137: 44 rpm; PW 6167:
41 rpm; PW 6207: 41 rpm.
Scooping PW 6107: 29 rpm; PW 6137: 29 rpm; PW 6167:
27 rpm; PW 6207: 27 rpm.
User-defined Settings for rhythm & speed are interdependent.
Counterclockwise only = Spin if speed is ≥ 300
rpm and Rhythm = No is programmed. If a
rhythm other than “No” is programmed, control
automatically reduces “User-defined” speed to
70 rpm if a higher speed was set.
From 20 rpm to 70 rpm in 1-rpm steps; Ranges
from 1 to 19 rpm and 71 to 299 rpm cannot be
selected.
From 300 rpm to max spin speed (see Table
100-36) in steps of 25 rpm; Ranges from 1 to 19
rpm and 71 to 299 rpm cannot be selected.
Rhythm setting must be “No”.
Table 100-35: Spin Phase Parameter Details
The No setting creates no spin profile. A spin profile with a time of zero
minutes and zero seconds does not produce a spin.
The Automatic setting gives the spin profile shown in Figure 100-9.
Figure 100-9: Speed/Time Diagram for Automatic Spin Setting
Ph1
Phase 1, pre-extraction, time 1 min 0 s, rhythm “No”, speed 500 rpm
Ph2
Phase 2, loosening, time 1 min 0 s, rhythm “12/3”, speed 30 rpm
Ph3
Phase 3, initial spin, time 1 min 0 s, rhythm “No”, speed 500 rpm
Ph4
Phase 4, spin, time 3 min 0 s, rhythm “No”, speed 850 rpm
Ph5
Phase 5, final spin, time 3 min 0 s, rhythm “No”, maximum permitted
spin speed for model
Ph6
Phase 6, loosening, time 2 min 0 s, rhythm “12/3”, speed 30 rpm
Max.
Maximum permitted spin speed selection; see also Table 100-36.
The User-defined setting could produce the example shown in Figure 100-
To Next Page
Loading...
Need help?
General
