Miele PWM 507 - Page 23

Before using for the first time
23
Removing the transit bars
The display will remind you to remove
the transit bars.
 Damage resulting from failure to
remove the transit bars.
Failure to remove the transit bars can
result in damage to the washing ma-
chine and to adjacent furniture or ap-
pliances.
Remove the transit bars as described
in “Installation and connection”.
 Confirm that the transit bars have
been removed with the OKsensor.
Continue setting up as described in the Op-
erating Instructionsappears in the dis-
play.
 Confirm the message with the
OKsensor.
Completing commissioning
To complete commissioning, the Col-
oured items 60°Cprogramme must be
run without laundry and without deter-
gent.
If the power is interrupted prior to the
start of the first wash programme (e.g.
if the machine is switched off with the
button), the initial commissioning
process can be completed again.
Once a wash programme has been
running for over 20minutes, the initial
commissioning process does not have
to be performed again.
 Open the stopcocks.
 Turn the programme selector
toColoured items 60°C.

1600
 
Coloured items
60°C
h
0:59
 Touch the Start/Stopsensor.
When the programme has finished, your
machine is ready for use.
If you have activated disinfection
programmes, you must complete the
Thermal disinfectionprogramme as
the first programme; make sure you
use a suitable detergent but do not
load the machine.