Cleaning and care
51
Remove the rubber seal(1) from the recess.
Using pointed pliers, take hold of the plastic filter bar(2) and
remove it.
Clean the plastic filter.
Reassemble in reverse order.
Turn on the tap and check the connection is watertight. If water
drips out, tighten the connection.
Cleaning the
filters in the water
intake valves
Using pliers, carefully loosen the ribbed plastic nut on the intake
valve and unscrew.
Use pointed pliers to withdraw the filter by the bar and clean it.
Reassemble in reverse order.
The filters must be refitted after cleaning.
To Next Page
Loading...
Need help?
General
