Installation
59
Hot water
connection
The same connection requirements as for cold water also apply to
hot water up to 70 °C.
A suitable connection hose with a threaded union is supplied with the
machine.
The machine with hot water connection also requires a cold water
connection.
Cold water
connection
For the cold water connection, one tap each with a ¾" screw thread
is required.
If a water connection is not available, only a qualified installer may
connect the washing machine to the mains water supply.
The inlet hose for cold water is not suitable for connection to a hot
water supply.
In the event that hot water is not available on site, a cold water supply
must be used for the hot water connection.
The required amount of hot water should be added to the cold water
volume.
Alternatively, the hot water connection should be blocked using the
blind stopper supplied with the machine and the machine controls
should be set to cold water intake by the service technician.
To Next Page
Loading...
Need help?
General
