Supervisor level
72
Further settings can be made after activating the dispenser pump.
- Deactivate disp. pump
- Calibration
- Flow rate (new): ml/min
- Correction factor
- Container size
- Adv. warning level reminder
- Reset adv. warning
- Level reminder
- Flow meter
Peak load
prevention
The peak load prevention function can be switched on or off. With
this function, the execution of a wash programme is not affected
when a peak load signal is in place. The heater stays switched on.
Machine parameters
Maximum spin
speed
The maximum spin speed can be set via a keypad.
Max. possible
temperature
The maximum temperature can be set via a keypad.
Legal information
Open source licences
You can view information here (see "Wi-Fi data protection").
To Next Page
Need help?
General
