-47-
About the slit lamp jig:
•
Attach the slit lamp jig only to slit lamp equipment that has been qualiĮed by MiiS. Make
sure the jig is completely locked by pushing it downward.
•
The slit lamp jig is only suitable for DEC 200.
Protect i on
•
Do not attempt to remove the cover from the product to prevent the product from mal-
functioning.
•
No modiĮcation of this device is allowed. The performance would be subject to anymodiĮ-
cation and may cause hazardous radiation exposure.
EMC (electromagnetic compatibility)
During installation and opera on of the device, observe the following instructions:
•
Do not use the device simultaneously with other electronic equipment to avoid electromag-
netic interference with the operation of the device.
•
Do not use or stack the device near, on, or under other electronic equipment to avoid elec-
tromagnetic interference with the opera on of the device.
•
Do not use the device in the same room as other electronic equipment, such as life-support
equipment that has major eīects on the life of the patient and results of treatment, or any
other measurement or treatment equipment that involves small electric current.
•
Do not use the system with portable and mobile radio frequency communication systems
because that may have an adverse eīect on the operation of the device.
•
Do not use cables or accessories that are not speciĮed for the device because that may in-
crease the emission of electromagnetic waves from the device and decrease the
immunity of the device to electromagnetic disturbance.
•
Do not touch the lens connecting pins of the control unit or the signal pad of the
lenses
without special precautions.
Cleaning and Disinfect i on
The device is a precision photo electronic instrument that shall be handled with speciĮc care.
Please note the following cleaning instructions:
•
Turn oī the device before cleaning it.
•
Disinfect the control unit and charging station with the so cloth with alcohol (75% ethyl
alcohol). Wait for the cleaning liquid to dissolve before turning the power on and con-
necting the charging station and USB cable to the control unit.
•
It is recommended to clean the optical lens with a cleaning cloth or lens cleaning
tissue
, such as THORLABS Inc. (www.thorlabs.com) lens cleaning t i ssue.
If a replacement for the eyecup is needed, please contact the manufacturer or
retailer. Clean the eyecup before each use:
•
Disinfect the eyecup with so cloth moistened with alcohol (75% ethyl alcohol).
NOTE
The device is not intended to be sterilized. Disinfect the control unit and charging station with
a soft cloth with alcohol (75% ethyl alcohol).
Miscellaneous
To Next Page
Loading...
