-45-
Step 2: Rolling the inner axis and the shaft to find out forehead stopper hole
Step 3: Tighten screw A in clockwise direction to forehead stopper hole.
Step 4: Remove correction plate of correction rod.
Step 5: Assemble rubber pad to the front end of inner axis.
Usage cautions and notes
When in use
•
The camera may become warm if used for long periods of time, but this is not its fault.
•
Keep the camera as far away as possible from electromagnetic equipment (such as micro-
wave ovens, TVs, video games, etc.).
•
Do not use the camera near radio transmitters or high-voltage lines.
VKDIWFLUFOHKROH
IRUHKHDGVWRSSHUKROH
LQQHUD[LV
VKDIWġ
screw A
correction plate
rubber pad
Miscellaneous
To Next Page
Loading...
