Milesight MS-C3262-FPNA - Page 87

81
Method2: Account registration mode
1) Before using the SIP, you need to register an account for the camera from the SIP server;
2) Register another user account for the SIP device from the same SIP server;
3) Call the camera User ID from the SIP device, you will get the video on the SIP device.
SIP Settings
Figure 4-4-27 SIP
Table 4-4-17 Description of the buttons
Parameters
Function Introduction
Unregistered/
Registered
SIP registration status. Display “Unregistered” or “Registered”
Enable
Start or stop using SIP
Register Mode
Choose to use Enable mode or Disable mode. Enable mode means to use SIP with
register account. Disable mode refers to use SIP without register account, just use the
IP address to call.
User ID
SIP ID
User Name
SIP account name
Password
SIP account password
Server Address
Sever IP address