Milesight MS-C3262-FPNA - Sip

80
Access List
Figure 4-4-26 Access List
Table 4-4-16 Description of the buttons
Parameters
Function Introduction
General Settings
Maximum number of concurrent streaming: Select the maximum number of
concurrent streaming. Options include No Limit, 1~9
IP access list
Rule: Single, Network and Range are available
IP address: Input the address to get the access to the device
Enable access list
filtering
Able to access or restrict access for some IP address
Filter type
Access or restrict access
4.4.6 SIP
The Session Initiation Protocol(SIP) is a signaling communications protocol, widely used for
controlling multimedia communication sessions such as voice and video calls over Internet
Protocol(IP) networks. This page allows user to configure SIP related parameters. Milesight
cameras can be configured as SIP endpoint to call out when alarm triggered; or allow permitted
number to call in to check the video if the video IP phone is used. To use this function, the settings
in SIP page must be configured properly. SIP can be achieved in two ways to get the video, one is to
dial the IP address directly, the other is account registration mode, the details are as follows:
Method 1: IP Direct mode
Dial on the camera’s IP address directly through SIP phone, so you can see the video(note: SIP
phone and the camera should in the same network segment).