TABLE OF CONTENTS
SECTION 1 − SAFETY PRECAUTIONS - READ BEFORE USING 1.................................
1-1. Symbol Usage 1.......................................................................
1-2. Arc Welding Hazards 1.................................................................
1-3. Additional Hazards For Installation, Operation, And Maintenance 3.............................
1-4. California Proposition 65 Warnings 4......................................................
1-5. Principal Safety Standards 4.............................................................
1-6. EMF Information 4.....................................................................
SECTION 2 − CONSIGNES DE SÉCURITÉ − LIRE AVANT UTILISATION 5...........................
2-1. Symboles utilisés 5.....................................................................
2-2. Dangers relatifs au soudage à l’arc 5......................................................
2-3. Dangers supplémentaires en relation avec l’installation, le fonctionnement et la maintenance 7.....
2-4. Proposition californienne 65 Avertissements 8..............................................
2-5. Principales normes de sécurité 8.........................................................
2-6. Informations relatives aux CEM 8.........................................................
SECTION 3 − DEFINITIONS 9..................................................................
3-1. Manufacturer Safety Symbols And Definitions 9.............................................
3-2. Miscellaneous Symbols And Definitions 11..................................................
SECTION 4 − SPECIFICATIONS 12..............................................................
4-1. Features And Benefits 12................................................................
4-2. Arc Controls 12.........................................................................
4-3. Serial Number And Rating Label Location 12................................................
4-4. Software Licensing Agreement 12.........................................................
4-5. Information About Default Weld Parameters And Settings 12...................................
4-6. Unit Specifications 12....................................................................
4-7. Dimensions And Weight 13...............................................................
4-8. Environmental Specifications 13...........................................................
4-9. Duty Cycle And Overheating 14...........................................................
4-10. Static Output Characteristics 14...........................................................
SECTION 5 − INSTALLATION 15................................................................
5-1. Selecting A Location 15..................................................................
5-2. Selecting Cable Sizes* 16................................................................
5-3. Weld Output Terminals 16................................................................
5-4. Remote 14 Receptacle Information 17......................................................
5-5. Optional 115 Volts AC Duplex Receptacle And Supplementary Protectors 17.....................
5-6. Electrical Service Guide 18...............................................................
5-7. Connecting 1-Phase Input Power 20.......................................................
5-8. Connecting 3-Phase Input Power 22.......................................................
SECTION 6 − GENERAL OPERATION 24.........................................................
6-1. Front Panel 24..........................................................................
6-2. Configuration Option Menu 25.............................................................
SECTION 7 − GMAW/GMAW-P/FCAW OPERATION 27.............................................
7-1. Typical Connection For Remote Control Feeder GMAW/GMAW-P/FCAW Process 27..............
7-2. MIG Welding Mode - GMAW/FCAW Process 28..............................................
7-3. MIG - Wire and Gas Selection Table 29.....................................................
7-4. Pulsed MIG Welding Mode - GMAW-P Process 30...........................................
7-5. Pulsed MIG - Wire and Gas Selection Table 31..............................................
7-6. Remote Process Select 32...............................................................
To Next Page
Loading...
