Miller Multimatic 220 AC/DC - 6-16. Factory Reset (Menu 8 Of 12); 6-17. Display Software (Menu 9 Of 12)

. A complete Parts List is available at www.MillerWelds.com
OM-281426 Page 41
6-16. Factory Reset (Menu 8 Of 12)
1 Material Thickness Minus (−)
Button
2 Material Thickness Plus (+)
Button
3 Auto-Set Button
. A Factory Reset will reset the
primary logs data, process logs
data, error logs data, selected
process, and all process set-
tings. Motor calibration set-
tings, Spoolmate Calibration
settings, and software informa-
tion will all be retained.
Follow instructions in Section 6-8 to
enter the setup menu.
To perform a Factory Reset, press
the Auto−Set button.
To exit menu, simultaneously press
and release the Wire/Rod/Tung-
sten Minus (−) button and Material
Thickness Plus (+) button, or turn
unit off and on.
Ref. 281252A
1
2
3
6-17. Display Software (Menu 9 Of 12)
. Display Software information is
for factory and service use
only.
Follow instructions in Section 6-8 to
enter the setup menu.
To exit menu, simultaneously press
and release the Wire/Rod/Tung-
sten Minus (−) button and Material
Thickness Plus (+) button, or turn
unit off and on.
Ref. 281252A