. A complete Parts List is available at www.MillerWelds.com
OM-281426 Page 44
SECTION 7 − MAINTENANCE & TROUBLESHOOTING
7-1. Routine Maintenance
! Disconnect power
before maintaining.
. Maintain more often
during severe conditions.
n = Check Z = Change ~ = Clean l = Replace
* To be done by Factory Authorized Service Agent
Reference
Every
3
Months
l Damaged Or Unreadable
Labels
l Repair Or Replace
Cracked Weld Cable
Every
6
Months
OR
~ Inside Unit ~ Clean Drive Rolls
7-2. Overload Protection
282718A
1
Supplementary
Protector CB1
CB1 protects unit from overload. If
CB1 opens, unit shuts down.
Reset supplementary protector.
1
To Next Page
Loading...
