Miller Subarc DC 650 - Selecting a Location; Typical Equipment Location

. A complete Parts List is available at www.MillerWelds.com
OM-265 363 Page 18
4-9. Selecting A Location
1 Lifting Eye
2 Lifting Forks
Use lifting eye or lifting forks to
move unit.
If using lifting forks, extend forks
beyond opposite side of unit.
3 Line Disconnect Device
Locate unit near correct input
power supply.
! Special installation may be
required where gasoline or
volatile liquids are present −
see NEC Article 511 or CEC
Section 20.
3
18 in.
(460 mm)
18 in.
(460 mm)
OR
1
2
Movement
Location And Airflow
4-10. Typical Equipment Location
Ref. 131 138-A
1 Welding Power Source
2 Side Beam
3 Interface
4 Spool Support
5 Wire Drive Assembly
6 Torch
1
2
6
3
4
5