. A complete Parts List is available at www.MillerWelds.com
OM-265 363 Page 37
Table 8-9. Status Flags (MODBUS 201)
Flag Name Bitmask Description
Valid Arc 0x0001 A valid arc has been detected.
Output On 0x0002 The power source output is on.
Run In 0x0004 The power source is in Run In.
Weld 0x0008 The power source is in the weld state.
Burnback 0x0010 The power source is in the burnback State.
Error 0x8000 The power source is in an Error Condition (read MODBUS Input Register 204).
Table 8-10. Weld Mode Look Up Table
Line Input Frequency (Hz)
Weld Mode Code
Mode Balance 60 Hz Line 50 Hz Line
CV Electrode Positive −− −− 0x0000
CV+C Electrode Positive −− −− 0x4000
To Next Page
