Mahr GmbH, Millimar C1208/C1216/C1240
MENU
Displays Millimar’s catalog of functions and pa-
rameters.
In the catalog of functions and parameters itself,
this key is used to switch between subfunctions
and enter numerical values.
When entering numerical values, this key is used
to move from one digit to the next (to the right).
The selected digit flashes to show that it can be
changed.
DATA
Used to navigate the catalog of functions and
parameters and to begin data transfer.
Within a function level of this catalog, this key is
used to scroll up in order to show further func-
tions/settings.
When setting numerical values, this key is used
to increase the value of the flashing (and there-
fore selected) digit by 1. If the number 9 is dis-
played when the DATA key is pressed, this will
change to 0.
Press the START key to stop entry
of numerical values. The numerical
value that has been entered flashes.
Press the START key again to adopt
the numerical value.
If the DATA key is pressed at the end of a mea-
surement and the interface has been set appro-
priately, data is transferred to a connected PC,
see Chapter 14.
MASTER
In measuring mode, this key is used to start a
master measurement.
In the catalog of functions and parameters, this
key is used within the selected function level to
scroll down in order to show further functions/
settings.
When setting numerical values in the catalog of
functions and parameters, this key is used to de-
crease the value of the flashing (and therefore
selected) digit by 1. If 0 is displayed when the
MASTER key is pressed, this will change to the
number 9.
Press the START key to stop entry
of numerical values. The numerical
value that has been entered flashes.
Press the START key again to adopt
the numerical value.
To Next Page
Loading...
