ESC
This key is used in the catalog of functions and
parameters to move from function sublevels to
the higher level.
When entering numerical values, this key is used
to move from one digit to the next (to the left).
The selected digit flashes to show that it can be
changed.
Pressing ESC when in setup mode exits this
mode.
Restoring factory settings
Pressing the ESC key immediately after switching
on the unit initializes the instrument, restoring all
the original factory settings. This is indicated by
“INITALL” appearing on the display.
— Hold down the ESC key when switching on
Millimar. The unit boots up and “INITALL”
is displayed. Once the boot-up process has
been completed “DEUTSCH (4.3.1)” flashes.
— Use the DATA and MASTER keys to set the
display language and press START (twice)
to adopt the selected language. “MM (4.4.1)“
flashes.
— Use the DATA and MASTER keys to set the
measuring unit and press START (twice) to
adopt the selected unit. “MAHR“ appears on
the display, followed by the standard display
elements.
To Next Page
Loading...
