Millipore DIRECT-Q 3 SYSTEM - Installation of the; Installation

INSTALLATION
- 14 -
HAZARD
!
4-4 INSTALLATION OF THE SMARTPAK
Open the Tank Outlet Valve before installing a
new SmartPak. This keeps the tank from filling
until the SmartPak is rinsed out (A).
Do not touch the UV Lamp when replacing the
SmartPak.
I
NSTALLATION
 Make sure the front cover is opened.
STANDBY should be viewed on the Display
(B).
 Remove the SmartPak from its shipping box.
 Remove the protective caps on the ports of the
SmartPak and from the system.
 Locate the O-rings on the ports (C). Wet them
with water. It is preferable to wet them with
ultrapure water.
A
B
C
ATTENTION