USING THE DIRECT-Q
- 35 -
5-7 HOW TO UNDERSTAND DIRECT-Q MESSAGES
PACK ALARM
The system will prompt you to change the SmartPak using a red
Pack Alarm icon. The Display will show the red Pack Alarm
blinking. The SmartPak is changed due to either the amount of time
it has been used or from the amount of water that has passed
through it.
When the Resistivity display is blinking, the red Pack Alarm will
also be blinking. This indicates that the SmartPak should be
replaced. This message is shown when the Product resistivity is less
than the Resistivity Setpoint. The Resistivity Setpoint can be seen
in menu option C02
When the red Pack Alarm is displayed as a steady icon, the
SmartPak is not installed correctly or not installed at all. If the
SmartPak has been reinstalled and the Alarm is still displayed, then
contact Millipore.
UV
LAMP ALARM
The system will prompt you to change the UV Lamp using a
red UV Lamp Alarm icon. The Display will show the red UV
Lamp Alarm blinking. The message is shown when the UV
Timer displays 0 days. The UV Timer can be viewed in
menu option C05. The replacement of the UV Lamp involves
the installation of a new UV Lamp and a manual reset of the
UV Timer.
When the red UV Lamp Alarm is displayed as a steady icon,
the UV Lamp is not installed correctly or not installed at all.
If the UV Lamp has been reinstalled and the Alarm is still
displayed, then contact Millipore.
To Next Page
Loading...
Need help?
General
