Millipore DIRECT-Q 3 SYSTEM - Purging Air from the System; Hydrating the System

INSTALLATION
- 18 -
4-7 PURGING AIR FROM THE SYSTEM
 At this time you should have installed the
SmartPak, Barbed Fitting and the Tygon
Tubing. Air trapped in the SmartPak should now
be purged from the system.
 Verify that you have a full tank of RO water by
viewing the Tank Level display (A).
 Press the Dispensing Button once to put the
system into DISPENSING mode (B).
 Dispense the full tank of water from the system.
 The system will go into FILLING TANK mode
when the tank level is below the 60% level (C).
 When the tank level reaches the minimum level,
the system will finish dispensing water.
4-8 HYDRATING THE SYSTEM
 At this time, the Final Filter is not installed.
Leave the system overnight or for several hours
in FILLING TANK mode or PRE OPERATE
mode (see Section 5-3 Operating Modes). The
system will regularly recirculate water and rinse
off purification media inside the SmartPak. Do
not leave the system in STANDBY mode.
 (The next morning) Press the Dispensing Button
once to put the system into DISPENSING mode.
 Allow about 1 Litre of water to be dispensed
from the system.
 Press the Dispensing Button once again. The
system will finish dispensing water.
 Remove the Tygon Tubing and the Barbed
Fitting from the POU Dispenser.
The Final Filter needs to be installed. See Section 4-9
Installation and Rinsing of the Final Filter.
A
B
C