Millipore DIRECT-Q 3 SYSTEM - How to View the; Emperature in Filling Ank Mode or in; Pre Operate Mode; How to View the Ro Permeate

USING THE DIRECT-Q
- 33 -
5-4 HOW TO VIEW THE PRODUCT RESISTIVITY AND TEMPERATURE
IN
FILLING TANK MODE OR IN PRE OPERATE MODE
Press:
The Display will show the last Product resistivity and temperature
values measured during DISPENSING mode or during
RECIRCULATION. The values are displayed for 5 seconds.
NOTE: The Product resistivity and temperature are displayed automatically during DISPENSING
mode or during RECIRCULATION.
5-5 HOW TO VIEW THE RO PERMEATE CONDUCTIVITY IN FILLING
TANK MODE OR IN PRE OPERATE MODE
Press:
The Display will show the RO Permeate Water conductivity value
that was measured during Filling Tank mode. The displayed value is
not a real-time value. It is the last permeate conductivity value
memorized after the system was in Dispensing Mode. The value is
displayed for 5 seconds.
NOTE: The units are displayed in μS/cm only.