Millipore DIRECT-Q 3 SYSTEM - Chapter 2: Product Information and Specifications; Direct-Q System Overview; Product Water Specifications; Schematic of Main Components

TABLE OF CONTENTS
CHAPTER 4 INSTALLATION ........................................................... 9
4-1 PREPARATION OF THE SYSTEM ...................................................................................................... 9
4-2 CONNECTION OF TUBING ............................................................................................................. 10
Feedwater Tubing .................................................................................................................................. 10
Reject Tubing ......................................................................................................................................... 11
Overflow Tubing .................................................................................................................................... 11
Tank Outlet Tubing ................................................................................................................................ 12
4-3 CONNECTION OF THE POWER CORD − TURNING ON THE SYSTEM POWER.................................. 13
Start-up Displays.................................................................................................................................... 13
4-4 INSTALLATION OF THE SMARTPAK.............................................................................................. 14
Installation ............................................................................................................................................. 14
Flush Mode............................................................................................................................................. 16
Rinsing the SmartPak............................................................................................................................. 16
4-5 INSTALLATION OF THE VENT FILTER........................................................................................... 17
4-6 INSTALLATION OF THE TYGON TUBING ....................................................................................... 17
4-7 PURGING AIR FROM THE SYSTEM ................................................................................................ 18
4-8 HYDRATING THE SYSTEM ............................................................................................................ 18
4-9 INSTALLATION AND RINSING OF THE FINAL FILTER.................................................................... 19
4-10 HOW TO CALIBRATE THE FLOWRATE FROM THE DIRECT-Q (F02).............................................. 20
4-11 HOW TO SHOW RESISTIVITY OR CONDUCTIVITY UNITS (C01) ................................................... 22
With Temperature Compensated or non Temperature Compensated values........................................ 22
4-12 HOW TO SET THE RESISTIVITY SETPOINT (C02).......................................................................... 24
CHAPTER 5 USING THE DIRECT-Q.............................................. 26
5-1 UNDERSTANDING THE DISPLAY................................................................................................... 26
5-2 HOW TO GET WATER FROM THE DIRECT-Q ................................................................................ 26
Product Water Using the Dispensing Button ........................................................................................ 26
RO Water Using the Tank Outlet Valve................................................................................................. 27
How to Dispense an Exact Amount of Product Water (F01) ................................................................ 28