Mindray BA-88A - Troubleshooting; Alarm Message Classification; Levels of Errors

4-3
5
Figure 4-22 Carryover
Select contaminating test in the Contaminating test list; select contaminated test in
the Contaminated test list. Select Save to save the setting.
4.7.5 LIS Setup
You can send the test result to LIS, after some parameters have been set is LIS
setup.
Figure 4-23 LIS setup
Enter specified information in LIS manufacture and LIS. Set the Index of Test
config., Result Setup, Unit and Type, according to the index No. provided by LIS.
The operation is as follows: Select Test config. and the list on the left side of the
screen shows all the test names on the system. Select one test and enter the index
on the LIS into the Index beside the test name.
After setting is completed, click Save to return to the main screen.