4-12
4.2.4 Off-system
All the tests that are not run by the analyzer are referred to as the off-system tests.
You can manually enter the off-system test results in to the system to print out them
in the patient report. For newly added off-system test, it is printed after the routine
tests. You can readjust the printing order in Setup.
Figure 4-9 Off-system
The following table explains the parameters on the off-system screen.
Parameter Description
Test The test name should be set and same test names are not allowed.
The length of the test name should not exceed 10 characters.
Otherwise, warning messages will appear.
Unit Unit of the result. Select from the drop-down list. The options
include g/L, mmol/L, umol/L, U/L, mg/dL, IU/L, mg/L and void. The
default is void. The units can be added and deleted in Setup.
Precision Precision of the result. Select from the drop-down list 1, 0.1, 0.01,
0.001.The default is 1.
Default
reference
Enter the normal range of the calculation. Refer to 4.2.1.2 for
details.
By Diff. Set the differential reference range of the calculation. Refer to
4.2.1.2 for details.
The following table introduces the buttons on the screen.
Buttons Function
Add Add a new off-system test.
Delete Delete selected off-system test.
Save Save the new off-system or the modified off-system.
To Next Page
Loading...
Need help?
General
