Mindray BeneFusion VP3 Vet - 4 Basic Operation; 4.1 Infusion Flow Chart

4-1
4 Basic Operation
4.1 Infusion Flow Chart
Load infusion set
Select brand
Purge air
Select infusion mode
Set infusion parameters
Connect to animal
Start infusion
Complete infusion
Turn pump on
Remove infusion set
Turn pump off
Press to activate and turn on the pump, the pump
will run start-up checks and display the start-up screen;
Please refer to 4.2.2 Load the Infusion Set;
Select according to the infusion set brand currently
being used;
Select infusion mode;
Refer to 4.2.8 Purge Air;
Refer to 4.2.9 Set Infusion Parameters;
Connect to animal;
Press ;
Press ;
Shut down the Robert clip (or flow rate regulator),
disconnect from the animal, and remove the infusion
set in a correct manner;
Hold down (>2s) , until the Power Off progress bar
complete.