Mindray CAL 8000 - Page 84

Operating the Control and Management Module (CMU)
6-8
 Adding a new order
You can add a new order as follows:
1.
Click "Add", a new line will be added to the order list.
2.
Define the "Rack Barcode From" and "To" in the added line, and then set up analysis
mode as needed.
3.
Click "Save" to save the settings.
NOTE
 Analysis will be run in the defined mode if the tube rack ID scanned has its
matched order in the system; or else, analysis will be run in the mode of the
default order.
 Deleting an order
To delete an order, select it in the list, and then click “Delete”. The selected item will be
deleted.
NOTE
 The default order cannot be deleted.
 Selecting the instrument to perform QC counts
You can select the instrument to perform QC counts using the switch on the bottom of the
screen. See the figure below as an example.