5 Exam Preparation
Operator’s Manual 5 - 5
1. Tap [Info] on the touch screen to enter the patient information page.
2. Click [Pause Exam].
If the system is powered off during scanning, the exam status turns “paused” after the system
restart.
When an exam is paused, the system will:
– Save the exam-related images, reports and measurement data, modify the status as
“Paused”.
– Save the exam information, including report, imaging mode, exam mode, image
parameters, operation mode, and imaging/measurement data and so on.
5.4.2 End an Exam
Before examining a new patient, tap [End] to end the exam of the previous patient, update the
patient ID and information, to avoid mixing data of the next new patient.
To end an exam, do one of the following:
• Tap [End] on the touch screen to finish the current exam.
• Click [New Exam] on the Patient Info screen (or iStation screen, or Review screen) to end the
last exam and clear the exam data.
To Next Page
Loading...
