Mindray Consona N9 Exp - Page 300

17 - 42 Operator’s Manual
17 Probes and Biopsy
NGB-039
Perform the following procedure:
1. Install the needle-guided bracket:
a. Put the sterile sheath on the probe.
b. Select a proper needle-guided bracket, and match the locating groove with the tab of the
probe. Mount the bracket onto the probe.
1 Angle blocking nut 2 Angle adjusting block
3 Angle mark 4 Angle adjusting base
5 Clamp 6 The clamping nut
7 Groove 8 Needle-guided bracket adjusting nut
9 Needle clamping cover 10 Needle guide hole
11 The pressing block for separating
needle
12 V-shaped guiding block

1
2
3
4
5
6
7

8
9
10
11
12