17 Probes and Biopsy
Operator’s Manual 17 - 51
right and left sides to fix the bracket and the probe. Rotate the needle-shaped adjusting nut
to the ultimate position as shown in the figure.
c. Hold the probe. Press the biopsy needle pressure position to separate it from the V-shaped
guiding block. Put the needle into the V-shaped guiding block of the needle guided-
bracket.
d. Hold the probe, and release the pressure position of the needle. Adjust the needle-shaped
adjusting nut manually (following the direction of the arrow). The needle moves smoothly
at the vertical direction due to its gravity.
2. Remove Needle-Guided Bracket.
To Next Page
Loading...
