3 - 14 Operator’s Manual
3 System Preparation
Setup
Select to enter the iVocal Setup menu.
• Add: Select [Add] to enter the Adding New Command menu, Select [Function Description] to
select the desired function, enter the user-defined command in the [Command] text box, and
then select OK.
User-defined command naming rules:
– Only Chinese characters, English letters, and digits are supported.
– The English letters are case-insensitive, consecutive blank spaces are not supported, and a
maximum of 128 letters are allowed when entering the English letters.
– Blank spaces are not supported and a maximum of 30 characters are allowed when
entering the Chinese characters.
– The user-defined commands cannot be empty.
– User defined commands that are already existed in the system but represent different
functions are not supported to be added.
• Test:
– Select [Test] and input a vocal command to the microphone device. After the vocal
command is recognized, the Success Rate is displayed in fraction. Select [Test] again to
close the vocal command test.
If the vocal command is successfully recognized by the system, both the denominator and
numerator of the Success Rate are added by 1 for each time; if the vocal command fails to
be recognized by the system, the denominator of the Success Rate is added by 1 for each
time through selecting the icon, while the numerator remains the same. For example:
2/3 represents 2 times of success and 1 time of failure.
– Clear: Select [Clear] to clear all the Success Rate test records.
• Recover: Select [Recover] to enter the Confirm menu. You can select Yes to restore to the
default settings.
• Wakeup mode: Select to enable wakeup mode. If the wakeup mode is enabled, the iVocal Plus
will automatically shut down after each command is executed. If the wakeup function is not
enabled, the iVocal Plus will only shut down after the waiting time.
• Enable voice response: Select to enable this function. When the function is enabled, the iVocal
Plus will respond to your voice command.
• Automatically shut down waiting time (Sec): Tap to enter number of the waiting time.
3 Click to open the Setup menu.
No. Description
Icon Function
Audition the vocal command
Edit the vocal command
Delete the vocal command
Clear the Success Rate test record of the selected vocal command
To Next Page
Loading...
