Duo™ Operating Instructions 0070-10-0603-01 2 - 5
Operation Initial Set-Up
Use the following procedure to change the units of measure.
1. Ensure that the power to the Duo is OFF.
2. Press and hold the Clear/Next Patient key.
3. While continuing to hold the Clear/Next Patient key, press and hold the
Power ON/OFF key for two (2) seconds until the Duo beeps.
4. Release both keys.
5. After an additional 2-second delay, the Duo will light the LED to show the currently
stored setting of the NIBP unit of measure.
6. Press the Clear/Next patient key repeatedly until the desired NIBP (mmHg or kPa)
unit of measure is showing.
7. Press the Power ON/OFF key for two (2) seconds to turn the Duo off and save the
new settings.
8. You may then turn the Duo back on to resume normal operation.
NOTE: The Duo cannot be placed directly back into normal
monitoring mode after setting the units of measure. It must
first be powered OFF.
To Next Page
Loading...
