10-8 DICOM
The system supports RGB (color printing) and
MONOCHROME2 (black and white printing). Please select
the type the printer supports.
Select between LANDSCAPE and PORTRAIT.
Specify printing task priority among HIGH, MED and LOW.
Select film size among the selections listed in the drop-down
list.
Specify quantity of printed files,e.g. STANDARD\2, 3
indicates 6 images are printed for each page.
Specify print medium: Paper, Clear Film, Blue Film.
Specify whether you want a trim box to be printed around
each image on the film: Yes or No.
Enter the minimum density of the film
Enter the maximum density of the film.
Enter configuration information in the field.
Specify where the file is exposed:
MAGAZINE (stored in the magazine), or
PROCESSOR (exposed in the processor)
Replicate: interpolated pixels belong to duplicate of adjacent
pixels;
Bilinear: interpolated pixels are generated from bilinear
interpolations between adjacent pixels;
Cubic: interpolated pixels are generated from cubic
interpolations between adjacent pixels; None: without
interpolation.
Select how the printer magnifies an image to fit the film.
Add the DICOM service to the service list.
Click to cancel the parameter setting.
Select an item in the service list, change the parameters in
the above area, and click [Update] to update the item in the
service list.
Click to delete the selected service in the service list.
Select an item in the service list, click [Default] and you can
see “Y” in the Default column.
Click to verify if the two DICOM application entities are
normally connected.
Click to exit the screen.
Parameter setting should be consistent with the printer performance:
For instance, if the printer cannot support film size to be “8IN*10IN”, please select the
printer supported size.
Settings: RGB is color printing and MONOCHROME2 is black and white printing.
To Next Page
Loading...