3.You can select the type of base plate attachment in the "Print Platform Attachment" tab.
Additional types of base plates include Raft, Brim, and Skirt.
Raft prints several layers of valve body similar to the base structure before printing the model. This
function can enhance the adhesion between the model and the printing base plate, reducing the risk of
model warping;
Note:
1. It is not recommended to print Raft when printing flexible materials;
2. It is not recommended to use PVA filaments to print Raft structures;
3.If the model size is greater than 150mm, it is recommended to prioritize using Raft structure.
Brim refers to a single layer that extends outward on the bottom layer of the model, which can
enhance the adhesion between the model and the printing substrate.
Skirt refers to the material layer extruded around the bottom layer of the model, ensuring
stable flow when printing the model.
32
To Next Page
Loading...
