Check points before operation
Preset and pattern Function Pre-Check
<Go Preset>
<Set Preset>
<Run Pattern>
<Set Pattern>
Input[Preset Number] and press [Preset] button shortly.
button] Preset[and press ] Preset Number[Input for more than 2 seconds.
P[Inputattern button] Preset[and press ] Number shortly.
button] Preset[and press ] Pattern Number[Input seconds٢ for more than .
OPERATON
Before power is applied, please check the cables carefully.
The camera ID of the controller must be identical to that of the target camera. The camera ID can be checked
by reading DIP switch of the camera．
If your controller supports multi-protocols, the protocol must be changed to match to that of the camera.
If you changed camera protocol by changing DIP switch，the change will be effective after you reboot the
camera
Since the operation method can be different for each controller available，refer to the manual for your
controller if camera can not be controlled properly. The operation of this manual is based on the standard
Pelco Controller.
R
Check how to operate preset and pattern function with controller or DVR in advance to operate camera
functlon tulIy when using controller or DVR.
Refer to the following table when using standard Pelco protocol controller.
If controller or DVR has no paflern button or function, use shortcut keys with preset nurnbers. For more
information,refer to“Reserved Preset”in this manual
3
11
Spee d Dom e Camera Instruction Manual
To Next Page
Loading...