minnkota.johnsonoutdoors.com | 19 ©2023 Johnson Outdoors Marine Electronics, Inc.
IDENTIFYING TROLLING MOTOR FEATURES AND THEIR ASSOCIATED CABLES
Control HeadControl Head
MountMount
Advanced Advanced
GPS GPS
Ethernet Ethernet
ConnectorConnector
Eight-Pin Eight-Pin
ConnectorConnector
Advanced Advanced
GPS Ethernet GPS Ethernet
ConnectorConnector
Coil CordCoil Cord
IDENTIFYING TROLLING MOTOR FEATURES AND THEIR ASSOCIATED CABLES
Feature & Cable Identification
Eight-Pin Eight-Pin
ConnectorConnector
Advanced GPS Navigation
Ethernet Cable Ethernet Cable
from Trolling Motorfrom Trolling Motor
Threaded Threaded
CollarCollar
The Riptide Instinct QUEST is pre-installed with Advanced GPS
Navigation - including the ability to connect via Ethernet to a
Humminbird fish finder. One Eight-Pin Advanced GPS Ethernet
Connector will exit the base of the Control Head and rest just
below the Control Head next to the Coil Cord.
If the Advanced GPS Navigation on the trolling motor will be
used with a fish finder, an Ethernet Cable may be attached to
the Advanced GPS Ethernet Connector. See the “Advanced GPS
Navigation” and "Securing the Ethernet Cable" sections of this
document for details on how to install the Advanced GPS Ethernet
Connector to a Humminbird fish finder.
Your Minn Kota trolling motor and Humminbird fish finder communicate with each other to change the way you fish. Advanced GPS
Navigation oers a large array of features including controlling speed, steering, Spot-Lock, and the ability to record and retrace paths
on the water, all at your fingertips. To learn more about the GPS capabilities available with your new motor, please refer to the Advanced
GPS Navigation Owner’s Manual by visiting
minnkota.johnsonoutdoors.com.
The Wireless Remote and GPS controller make up the Advanced GPS Navigation system. A Wireless Remote comes paired to the
controller from the factory. The GPS controller contains a very sensitive compass and is where all GPS satellite and remote signals are
received. The GPS controller is located in the trolling motor Control Head and may be connected to a fish finder from a connection cable
that exits the Control Head. If the Advanced GPS Navigation system will be used with a fish finder, the Ethernet link between the trolling
motor and the fish finder should be connected.
ADVANCED GPS NAVIGATION
Feature & Cable Management