50 | minnkota.johnsonoutdoors.com ©2023 Johnson Outdoors Marine Electronics, Inc.
TRIMMING WITH THE OBN APP
Trimming with the OBN App
a. Open the One-Boat Network (OBN) app on the
mobile device. Make sure the mobile device is paired
with the trolling motor.
b. From the OBN home screen, tap the Motor menu.
The Motor menu opens the Motor home screen.
c. Before the Motor home screen will open, tap Agree
on the on-screen prompt.
1
2
NOTICE: The on-screen prompt will only display once
each time the app is launched. If the prompt has
displayed, the Motor home screen appears after.
d. Tap Trim/Stow on the bottom of the screen to open
the Trim/Stow/Deploy menu.
e. To trim the motor up, press and hold Trim Up
.
Continue to hold until the lower unit is at the
desired height.
f. To trim the motor down, press and hold Trim
Down
. Continue to hold until the lower unit as at
the desired height.
1b1a
NOTICE: To avoid churning or agitation of surface water, ensure that the top of the motor is submerged at least 12" below the
surface of the water.
WARNING
When trimming the motor, keep fingers clear of all hinges,
pivot points and all moving parts.
NOTICE: The red area
is the Prop Lockout
region. The Prop will be
automatically disabled if
the lower unit is trimmed
into this zone, and the
Prop icon will turn gray. To
restore Prop functionality,
trim the lower unit out of
the Prop Lockout region.
WARNING
While Trim Up or Trim Down is pressed, the motor will
automatically trim. Be sure the motor is clear from
obstructions and has a clear path of travel. The Prop is
disabled while the motor is being trimmed to prevent
accidental contact with the rotating Prop.
2d 2e
To Next Page
Loading...
Need help?
General
