LOADING 35MM FILM HOLDERS
15
SLIDE MOUNT HOLDER SH-M1
• The slide mount holder can hold up to 4 mounted slides (35mm or APS).
• Slide mounts must be thicker than 1mm and thinner than 2mm to fit properly into the holder.
• Results of scanning glass-mounted slides can be unpredictable.
• Blow dust off the slide before placing it into the film holder.
1.Position the slide mount
holder so the white arrow is
on the top-left side, then open
the slide mount.
• Open the slide holder by pushing up
on the two tabs from underneath.
2.Place the slides within the
indentations, making sure
they lie flat.
• Insert the slides emulsion side down.
3.Press the cover firmly closed
until it clicks.
To Next Page
Loading...
