LOADING THE MEDIUM FORMAT HOLDER MH-M1
18
USING THE MEDIUM FORMAT HOLDER MH-M1
MEDIUM FORMAT AND TEM FILM
Use the MH-M1 for 120/220 film frames in 6x4.5, 6x6, 6x7, and 6x9 formats. The MH-M1 should also be used for
sleeved APS film, 16mm film, and TEM* film. Use the appropriate film mask for each film format. The glass in the
Medium Format Film Holder MH-M1 has been treated to prevent the appearance of Newton’s rings (colored rings)
when scanning.
• Handle the Medium Format Film Holder MH-M1 with care. Protect the glass from impact, shock, and scratches.
• Touching the glass in the film holder may cause damage to the antinewton treatment.
• Blow away any dust from the film holder before inserting the film. If the film holder is dirty, first blow away any dust
or debris, then moisten a lens cleaning tissue with lens cleaning fluid and gently wipe the surface.
* Transmission Electron Microscope
1.Press on the lever marked
“PUSH”, then lift open the
holder.
2.Select the appropriate mask
and place it in the film holder
using the guides.
• The cut corner on the mask should be
on the bottom-left side.
• Choose the appropriate size mask for
TEM film.
Align the holes in the mask with the pins on the film
holder.
Align the slot in the
mask with the rail
on the film holder.
To Next Page
Loading...
Need help?
General
