EasyManuals Logo

Minolta DiMAGE Z1 User Manual

Minolta DiMAGE Z1
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
49
The number of images that can be captured at one time depend on the image-quality and image-size
setting. The maximum rate of capture is approximately 1.5 fps. The built-in flash can be used, but the
rate of capture is reduced because the flash must recharge between frames. Date imprinting (p. 92)
also reduces the rate of capture.
The following chart lists the maximum number of images that can be captured with different image-
quality and image-size combinations.
Economy
Standard
Fine
2272 X 1764 1600 X 1200 1280 X 960 640 X 480
5
10
19
8
16
30
13
24
42
42
67
94
Continuous-advance notes
Quality
Size
CONTINUOUS ADVANCE
UHS CONTINUOUS ADVANCE
UHS continuous-advance captures up to ten 1280x960 images at 10fps regardless of the image
quality setting. The built-in flash cannot be used. When the red low-battery warning is displayed, this
drive mode cannot be used.
During recording, the live image can be seen. When the maximum number of frames is captured, the
last frame of the series is displayed. A thumbnail of each frame in the series is shown in a six-frame
index display while being saved; the first six image are replaced by the following images after they
are displayed.
Very bright light sources in the scene may cause streaks to appear on the image. Black areas
caused by data loss may also be apparent.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Minolta DiMAGE Z1 and is the answer not in the manual?

Minolta DiMAGE Z1 Specifications

General IconGeneral
BrandMinolta
ModelDiMAGE Z1
CategoryDigital Camera
LanguageEnglish

Related product manuals