111
Memory cards
SD Memory Cards and MultiMediaCards are manufactured with precision electronic components.
The following may cause data loss or damage:
• Improper use of the card.
• Bending, dropping, or subjecting the card to impact.
• Heat, moisture, and direct sunlight.
• Static electrical discharge or electromagnetic fields near the card.
• Removing the card or interrupting the power supply while the camera or a computer is accessing
the card (reading, writing, formatting, etc.).
•Touching the electrical contacts of the card with your fingers or metal objects.
• Using the card beyond its life. Purchasing a new card periodically may be necessary.
The response time is longer with MultiMediaCards compared with SD Memory Cards. This is not a
defect, but rather due to the specifications of the cards. When using large capacity cards, some oper-
ations like deletion may take longer.
SD Memory Cards have a write-protect switch to prevent image data from
being deleted. By sliding the switch to the bottom of the card, the data will
be protected. Images cannot be recorded when the card is protected. If an
attempt is made to record or delete an image with the camera, the card-
locked message will appear on the monitor.
Memory cards should not be used to permanently store image data.
Always make a copy of camera files on an appropriate storage device or
recording media. Minolta has no responsibility for any loss or damage to
data.
Before important events and journeys
• Check the camera’s operation; take test pictures and purchase spare batteries.
• Minolta has no responsibility for any damage or loss incurred by equipment malfunction.
Write-
protect
switch
Lock
position
To Next Page
Loading...
Need help?
General
