U-24 Sort/Non-Sort switching ON/OFF
•
Specifies whether to enable or disable the function that automatically switches
between the Sort and Non-Sort Mode under either of the following conditions
when the copier is equipped with a Sorter or Staple Sorter and a
Duplexing/Automatic Document Feeder.
<Condition>
•
The copy cycle is initiated using a single original in the Sort Mode.
•
The copy cycle is initiated to make two or more copies using two or more
originals in the Non-Sort Mode.
Setting Value Description Initial Setting
0 Sort/Non-Sort switching OFF
1 Sort/Non-Sort switching ON
O
U-51/52/53/54 Special paper setting
•
Sets up a Drawer for special paper loading.
U-51: Special paper setting for 1st Drawer
U-52: Special paper setting for 2nd Drawer
U-53: Special paper setting for 3rd Drawer
U-54: Special paper setting for 4th Drawer
If "0" is selected:
The Drawer is not set for special paper loading.
If "1" is selected:
The Drawer is set for special paper loading.
Special Paper Setting
A Drawer, if set for special paper loading, is excluded from a port that can be
selected in the Auto Paper Mode.
To use the Drawer which is set for special paper loading, you need to first set the
copier into the Manual Mode and select that port manually.
If a Drawer is set for special paper loading and loaded with special paper, that
Drawer can be used only for that purpose.
Setting Value Description Initial Setting
0 Special paper setting is not made.
O
1 Special paper setting is made for the Drawer.
4. User’s Choice
Chapter 4
Special Function
102
To Next Page
Loading...
