Ripple = Throttle Displaced
Looks similar to the start up above. Repeats. The drive switch has been
activated while powering up the machine. Place the throttle in the neutral
position and turn the control system on and off again. Possibly the drive
switch is stuck on.
Start UP
This is an initialization message. Repeats until system is verified to be functional.
Occurs during the initial startup of the machine, if it hasn’t been powered up for a
period of time. Note: This is not a fault or error.
9.1 E17TD & E20TD Error Codes
Page 37
To Next Page
Loading...
