To Next Page

To Previous Page

Basic Post Installation Checks

1. Turn on electrical

supply.

3. Temperature to full

cold.

4. Start shower to test for

water ow. If a shower

drain pump is tted, it

should also start.

5. If there is no water

after 5 seconds, make

sure that appliance

has been primed.

5 secs

2. Power to appliance,

check Start/Stop for

blue light.

6. Push Start/Stop to

turn off appliance.

Pulsing light and

"beep" indicates that

appliance is shutting

down.

7. Appliance will purge water from

heater tank for a few seconds.

Important! DO NOT isolate power

until water has stopped.

Go to section: "Commissioning".

Mira Advance ATL J97C User Manual

Questions and Answers: