24
1st Beep (LONG) - Release START/STOP.
2nd Beep (SHORT) - Release FLOW.
4.
5. HIGH FLOW LIGHT FLASHES
This indicates shower is commissioning correctly.
Water ows for approximately 1 minute 20 seconds.
In some cases the cycle can take up to 3 minutes.
Allow shower to stop automatically.
IMPORTANT! DO NOT INTERRUPT THE CYCLE!
6. Push START/STOP to turn shower ON.
Check that maximum temperature is
acceptable to the user.
COMMISSIONING FAILURES
(the commissioning cycle was stopped due to an error)
No ashing FLOW LIGHT... solution ...Restart the commissioning cycle.
No water after 5 seconds... solution ...Reprime the shower. (See "Installation".)
WATER SUPPLY or
RESET light is on................ solution ...Reprime the shower. (See "Installation".)
_
+
7. Push START/STOP to turn shower OFF.
Wait until water has stopped flowing
BEFORE turning Power/Electric OFF.
8. Residual water may drain over a few
minutes.
OFF
To Next Page
Loading...
Need help?
General
