6
12. DO NOT t any form of outlet ow control (e.g. trigger handsets) as the outlet
acts as a vent for the tank body. Only Mira recommended outlet ttings should
be used.
13. This product is not suitable for areas with high humidity (i.e. steam rooms).
14. THIS APPLIANCE MUST BE EARTHED. MAKE SURE SUPPLEMENTARY
BONDING COMPLIES WITH THE ‘REQUIREMENTS FOR ELECTRICAL
INSTALLATIONS’ BS7671. This electric shower is intended to be permanently
connected to the xed electrical wiring of the mains system.
15. This appliance must be provided with means for disconnection that is
incorporated into the xed wiring in accordance with the relevant local wiring
regulations.
16. This appliance is suitable for installation within the shower area. It must be
positioned over a water catchment area with the controls at a convenient height
for the user. The shower tting should be positioned so that it discharges down
the centre line of the bath, or across the opening of a shower cubicle, and must
be directed away from the appliance.
17 DO NOT tile up to the sides of the shower or use sealant around the case (see
section 'Installation Requirements').
CAUTION!
1. Read all of these instructions and retain this guide for later use.
2. The electrical installation must comply to 'BS 7671 (commonly referred to as the
IEE Wiring Regulations) and all relevant building regulations, or any particular
regulation or practice specied by the local electricity supply company.
3. The plumbing installation must comply with all national or local water regulations
and all relevant building regulations, or any particular regulation or practice
specied by the local water company or water undertakers.
4. Switch off the appliance at the electrical isolating switch when not in use. This
is for safety and is recommended with all electrical appliances.
5. This appliance is not suitable for use with any form of electronic timer. The
shower must be shut down in accordance with the instructions contained in
this installation guide, or the separate user guide.
6. Having completed the installation, make sure that the user is familiar with the
operation of the appliance.
7. When this appliance has reached the end of its serviceable life, it should
be disposed of in a safe manner, in accordance with current local authority
recycling, or waste disposal policy.
8. Please pass this guide on in the event of a change of ownership of the installation
site.
To Next Page
Loading...
Need help?
General
