miRider One - Page 22

22
· Only charge the battery with the provided charger. Ensure the voltage of the charger
matchesthevoltageofthebattery.Non-matchingvoltagesmaycauseareor
explosion hazard.
· Alwayskeepthebatteryandthechargerclean.Useacleanfreshclothtowipeoany
dirt. Dirt may cause an electric shock hazard.
· Do not use the battery or charger if there is visible damage. A damaged battery or
charger may cause an electric shock hazard.
· Donotusethebatteryorchargeronhighlyammablesurfacesorinacombustible
environment.Theheatgeneratedduringchargingmaycausearehazard.
· Donotuseorstorethebatteryandchargernearheatsourcesandhighlyinammable
liquids. Using or storing the battery and charger near heat sources may cause an
explosion hazard.
· Donotchargethebatteryunattended.Unattendedbatterychargingmaycauseare
hazard.
· Do not store the battery near paper clips, coins, keys, nails, screws, or other small metal
objects which may cause short circuiting. Short circuits between the battery contacts
maycausearehazard.
· As with all mechanical components, the e-bike is subjected to wear and high stresses.
Dierentmaterialsandcomponentsmayreacttowearorstressfatigueindierent
ways. If the design life of a component has been exceeded, it may suddenly fail,
possibly causing injuries to the rider. Any form of crack, scratches or change of
colouring in highly stressed areas indicate that the life of the component has been
reached and it should be replaced.
· Do not try to unfold your e-bike with the handlebar set too high. Unfolding your e-bike
with the handlebar set too high may pull out the connecting cables and may lead to
loss of control of your e-bike during cycling or failure of the e-bike.