miRider One - Page 23

23
· Do not lubricate the disc brakes. Lubricating the disc brakes may cause brake failure
which may lead to loss of control of your e-bike during cycling.
· Do not lubricate the drive belt. Lubricating the drive belt may cause the drive belt to
slip and void warranty.
6
CAUTION
· Before each journey, check that:
– the lighting and bell operate correctly and are correctly attached.
– the brakes operate correctly.
– the brake levers are adjusted correctly. If you can squeeze the lever all the way to
the handle, there is air or a leak in the brake line. Do not use the e-bike and have the
brake line bled or repaired by an approved MiRiDER dealer.
– the tyres and rims are free of damage and the wheels can turn unimpeded.
– thetyresarepumpedtothecorrectpressure.Insucienttyrepressuresmayleadto
premature wear, reduced grip and higher energy consumption of the e-bike system.
– there are no sharp particles in the treads of the tyres that may puncture the tyres.
– the suspension of the front fork works correctly and the front fork is securely
attached.
– all bolts, nuts, latches, and clamps are tight.
– the frame and the front fork show no deformations, cracks, or damage.
– the stem and handlebars are correctly and securely attached and the handlebars are
at the correct height and angle.
– the seatpost and saddle are correctly and securely attached and the saddle is at the
correct height and angle.
· The above checks should also be carried out after a collision/crash. Do not use the
e-bike if a part no longer functions correctly or is broken/deformed.