Mirtone QuickStart - Configure Dialer Receivers and Retry Attempts; Set Subscriber Account Numbers

Mirtone QuickStart Front Panel Programming Getting Started Guide 11
DIALER SETUP NUMBER RECEIVE PHONE NUMBERS RETRY (5-10)
1) #’s of CMS 1) 1 1) Rcvr 1 Prim # 05
2) CMS Phone Number 2) 2 2) Rcvr 1 Sec #
3) Retry Count 3) Rcvr 2 Prim #
4) Accounts 4) Rcvr 2 Sec #
5) Default Msgs 5) Exit
To set the number of dialer receivers:
1. From Dialer Setup choose #’s of CMS then choose how many CMSs (central
monitoring stations) the dialer will call.
2. Choose CMS Phone Number, enter the correct phone numbers for each receiver, then
choose Exit.
If there is only one receiver, then you don’t need to enter values for Rcvr 2 Prim #
and Rcvr 2 Sec #.
3. Choose Retry Count and enter the number of times the dialer should attempt to
contact the CMS (from 5 to 10 times).
Subscriber account numbers
Next, set up the account numbers.
DIALER SETUP ACCOUNTS ACCOUNTS FORMAT
1) #’s of CMS <New> 1) Account # 1) 4/2
2) CMS Phone Number 2) Formats 2) Contact ID
3) Retry Count 3) Test - normal
4) Accounts 4) Test - abnormal
5) Default Msgs 5) Test Time
6) CMS
7) Delete
8) Exit
To set the dialer account numbers:
1. From the Dialer Setup menu, choose Accounts then New.
The system displays the full Accounts menu.
2. Choose Account # and enter the subscriber’s account number.
3. Choose Formats and choose either 4/2 or Contact ID. (For our example project,
choose contact ID.)