Need help?Do you have a question about the Mirtone QuickStart and is the answer not in the manual?
Details the specific application scenario for the example project.
Lists the hardware components used in the example project.
Configures dialer receivers, associated phone numbers, and retry logic.
Sets up unique account numbers for subscriber monitoring.
Defines default message strings for alarm, trouble, and supervisory events.
Guides the process of auto-looping SLIC cards to find addressable devices.
Enters descriptive labels for the facility, company, and programmer.
Configures basic system parameters like alarm/reset inhibit and AC power delay.
Sets up the configuration for an SLIC card, including signal circuits and wiring class.
Details the steps to configure individual SLIC detectors, including messages and settings.
Outlines the process for configuring SLIC modules, including type and personality.
Procedure to remove the default output group 250.
Steps to create new output groups for system functionality.
Instructions for associating dialer strings with output groups.
Process for creating zones and linking them to output groups.
Guides on enabling the system's device mapping feature.
Troubleshooting steps for resolving map faults after enabling mapping.
Process for adding new signature devices to an existing system.
Procedure for removing signature devices from the system.
Steps to replace an existing signature device with a new one.
General| Brand | Mirtone |
|---|---|
| Model | QuickStart |
| Category | Motherboard |
| Language | English |
To Next Page