Mirtone QuickStart - Define Default Dialer Message Strings

Mirtone QuickStart Front Panel Programming Getting Started Guide 14
Default strings
60200000 Normal Test String
60800000 Abnormal Test String
11000000 Alarm
20000000 Trouble
30000000 Supervisory
Each of these events is preceded by either an activation code (1) or a restoration code (3).
For example, to send a waterflow activation, the string would be 111300000. For the
corresponding restoration, the string would be 311300000. The system events are
considered pseudo points (internal) and require the Configuration Utility to program.
Dialer setup - default message strings
DIALER SETUP DEFAULT MSGS [TYPE] MSG
1) #’s of CMS 1) Alarm 1) Account
2) CMS Phone Number 2) Trouble 2) Active Msg
3) Retry Count 3) Supervisory 3) Restore Msg
4) Accounts 4) Exit 4) Exit
5) Default Msgs
To set the dialer default message strings:
1. From the Dialer Setup menu, choose Default Msgs (messages).
2. From the Default Msgs menu, choose Alarm.
3. From the Alarm Msg menu choose Account, then select the subscriber account to
receive the message.
4. Choose Active Msg then enter the default alarm dialer string (for Contact ID it’s
111000000).
5. Choose Restore Msg then enter the default alarm restore dialer string (for Contact ID
it’s 311000000).
6. Choose Exit.
7. Repeat steps 2 through 6, choosing Trouble, then Supervisory in step 2.
The default trouble strings are: Active - 120000000, Restore - 320000000.
For supervisory use: Active - 130000000, Restore - 330000000.