Mirtone QuickStart Front Panel Programming Getting Started Guide 15
8. Choose Exit from the Default Msg menu, then Exit from the Dialer Setup menu.
9. Choose Save Edits.
10. From the Update Database menu choose Save and Sync. (If there are no remote
annunciators in your actual project, choose Save).
The system goes through its reboot process.
This completes the AutoLearning process for the panel. If there is an SLIC module
installed in the panel, as with our example project, the system displays an “Unconfigured
Device” trouble message after initializing. To clear this you run AutoLoop, as discussed
in the next topic.
To Next Page
Loading...